Where is the PCM relay on a 2003 Ford Explorer?
The relay box is located on the rear passenger side quarter trim panel.
Where is the starter solenoid on a 2003 Ford Explorer?
The starter relay in a 2003 ford explorer is located in the main fuse panel under the hood, and is in the middle of the line of relays on the right side of the panel.
What would cause a 2002 Ford Explorer to not start?
Check for adequate fuel pressure, injector operation, and a spark at the spark plugs. Other possible no start faults are low compression, failed fuel pump, defective spark plugs, a defective coil(s), a failed crankshaft or camshaft position sensor, a failed throttle position sensor, and a broken timing belt.
How do you reset the anti theft system on a Ford Explorer?
Key
- Insert the key into the driver’s side door lock.
- Turn the key once, but not all the way to unlock the door. Leave the key in this position for 40-60 seconds.
- Do this again, but turn the key in the opposite direction.
- Remove the key from the door, get into your Ford, and start the engine. The system should be reset.
Where is the fuse for the power windows on a 2003 Ford Explorer?
That’s the fuse block under the hood adjacent to the battery.
What is a PCM power relay?
The PCM (powertrain control module, also known as ECM or engine control module in other vehicle makes) comes with a power relay that provides battery voltage safely to the right PCM circuits. It’s a contact type relay activated with a signal wire from the ignition switch.
Where is the starter fuse on a 2002 Ford Explorer?
The 2002 ford explorer starter relay is located in the fuse panel under the hood.
How do you bypass anti theft on a 2001 Ford Explorer?
First, go to the driver’s side of Your vehicle, and insert the key into the lock. Turn the lock to the right, or to the unlock position. Hold this position and count for 25 to 40 seconds. Doing this will bypass the anti-theft system.