Where is the blend air door actuator located?
The blend door actuator(s) are typically located on the climate control case behind the dashboard.
How long does it take to install a blend door actuator?
Replacing the blend door actuator is actually a fairly simple process, and it should take no more than an hour. So the labor will cost you around $75 – $150 depending on labor rates at your local repair shop. In general, you can expect the total cost to be no more than $400.
How much does it cost to get a blend door actuator replaced?
The average cost ranges from $100 to $400 for an HVAC blend door actuator replacement in your vehicle.
What is an air blend door actuator?
This is a common problem in most car’s heater and air conditioner systems. How Does It Work? An air blend door actuator is constructed from a plastic housing, a small electric motor and a plastic gear set.
Where is the HVAC actuator located on a furnace?
These units can be either hanging in front of you or in a little more obscure places such as on the side the HVAC plenum. Sometimes they can be located in inconvenient places like the top of the heater box. These repairs can take a little longer because more parts need to be removed to gain access to the actuator.
How do I remove the actuator on my Kenmore dryer?
There should be two or three screws holding it in place. A small universal might be needed to help remove the screws in awkward places. Once removed place the screws into a small container so they don’t get lost. Once all of the mounting screws have been removed the actuator should become loose.
Where can I get a replacement actuator?
You can get an OEM replacement actuator from Amazon for what the garages pay for them in most cases. You will need a tool set including an 5.5 mm socket for Chevy, GMC, Cadillac, Ford and Lincoln vehicles.