How do you turn off Leviton motion sensor?

How do you turn off Leviton motion sensor?

The lights will remain ON as long as the unit detects activity in the sensor zones. The IPP15-1L will turn the lights OFF automatically after the space becomes vacant and the delayed- OFF time expires. Lights also can be turned OFF manually at any time by pressing the push-button.

How do I reset my motion light stays on all the time?

Reset your Motion Detector – To reset your motion light, unplug it from its power source for a full 10 seconds. Plug it back in and allow it to come back on. This should reset your light and turn off the auto-on function.

How do I make my motion sensor light switch stay on?

One of the quick tricks you can try is to quickly turn the motion sensor ON, OFF, ON to override the motion detection and make the light stay on. To go back to motion detection mode, turn the motion sensor switch off and wait for about 10 seconds, and then turn it on again.

How to adjust Leviton motion sensor?

Normally the switch is kept on all the time.

  • If you turn the switch off and on within a second or so,the light will stay on,and this overrides motion detection.
  • To go back to normal operation,turn the switch off and wait ~10 seconds,then turn back on.
  • What is the best motion sensor light switch?

    – Three-way light switch – Adjustable timer, sensitivity, and light detection – Automatic and manual use

    How to connect motion sensor switch for lights?

    Preparations. Preparation is vital to avoid putting yourself in harm’s way.

  • Disassemble the Fixture. Using a screwdriver,start to disassemble the fixture to gain access to the wiring.
  • Working the Wire Connections.
  • Remove Knockout.
  • Setting the Rubber Washer.
  • Mounting the Sensor.
  • Preparing the Wires.
  • The Black Wires.
  • The White Wires.
  • The Ground Wires.
  • How to install a motion sensor switch?

    Motion Sensor Light Switch Directions. Step 1: Shut off the electrical breaker at the electrical panel. Step 2: Remove your existing light switch plate cover and pull out the existing switch from the wall. Step 3: Remove the existing switch by unscrewing the two screws holding the wires in place.