Are pool light niches universal?
The light niche is the sideways “bucket” that holds the pool light into the wall. lamp will fit pool light niches by American, Anthony, Hayward, Pac-Fab, Paragon, Pentair, Purex, Sta-Rite and Swimquip. It’s universal because it will fit into most any other pool light niche.
What size pool light do I need?
How Many Pool Lights Are Needed? The number of lights needed properly to illuminate your pool is obviously going to depend on the size of your swimming pool. As a rule of thumb, the generally recommended requirement is to aim for 5.4 watts per square metre (0.5 watts per square foot).
How long do underwater pool lights Last?
Most incandescent bulbs will burn for 1,000 hours before bulb replacement is necessary. LED bulbs can burn for 25 years or more (or so they tell us).
How do I tell if my pool light is 12V or 120V?
Check the back of the light housing where the cord connects into the light, there will be a label specification of your light. The brightness of a 12V and 120V will be the same.
Are LED pool lights worth it?
An LED light will save you roughly 75% on your energy usage compared to a comparable incandescent light. REMEMBER, that LED pool lights cost more, on average, than a simple incandescent light so your cost savings will not start till you recoup the additional money that you spent on the LED lights.
How much does it cost to install a pool light?
At the time of this writing, full size LED pool lights, like what are typically installed in vinyl liner or concrete pools, usually cost between $1,000 and $1,500 installed. The smaller LED lights like the Pentair Globrite or PAL 2000 typically cost between $700 and $900 installed.
Do LED pool lights burn out?
Simply, LEDs are tiny light bulbs that fit into an electrical circuit in the lamp. They don’t have a filament that will burn out, allowing them to run much cooler and last longer than regular incandescent bulbs. Unlike incandescent bulbs, LED pool lights will continue to work even if one LED burns out.
Do pool lights burn out?
Just like any light, the bulb can burn out and will need to be replaced. There is no need to lower the water level in your pool to replace the burned-out bulb. Instead, you can remove the light housing from the side of the pool, pull the fixture up onto the side of the pool, and change the light bulb there.
How much does it cost to replace a pool light bulb?
A pool light bulb retails for about $30-40. A new pool light gasket for the fixture is about $25. Labor for the repair would be $100-150. Profit on a successful job would be about $120.
Can you change a pool light without draining the pool?
Replacing pool lights for your in-ground swimming pool does not require draining the water from the pool or hiring a professional. The design of the pool light’s housing allows you to remove it from the pool without the need to disconnect any wiring.