How wide is a G-body rear end?
Products specifications
| Vehicle Fitment | 78-87 GM G-body vehicles (Malibu, Monte Carlo, Monte Carlo SS, El Camino, Regal, Grand National, Cutlass, Cutlass 442, Cutlass Salon, Grand Prix, Caballerro and Station Wagons) |
|---|---|
| Brake Space | 2.5 inch axle standoff |
| Width | 58 inches (between wheel mounting surfaces) |
How wide is a Monte Carlo rear end?
MEASURED ACROSS WHEEL MOUNTING SURFACE
| Year | Classic Vehicles | Width Rear |
|---|---|---|
| 78 & up | Monte Carlo, Regal, etc. with 10 bolt axle | 58″ |
| 68-72 | Chevelle with 10 bolt axle | |
| 89 | Trans AM (Disc brake) | |
| 76-80 | Camaro / Firebird | 60 ½” |
What is a Grand National rear end?
Product Summary. Grand National, Rear Position, Full Floating Axle Type. This 9″ Grand National rear end kit uses a Newly Fabricated housing with new 3″ tubes and ends. Complete kit includes a housing, hubs, 31 spline axles, rotors, bearings, seals, and hardware needed to assemble the rear end.
How can I tell if I have a 8.5 rear end?
Another way to tell the difference between an 8.2 and an 8.5 rearend is to pull the cover and look at the bolt holding the spider gear crosspin. If it takes a 1/2-inch wrench to remove it, it’s an 8.2. If it takes a 5/16-inch wrench to remove it, it’s an 8.5.
How wide is a Fox body rear end?
How To Spot, Build, And Swap In the Ford 8.8 Mustang Rearend.
| Vehicle Application | Axle Width (inches) |
|---|---|
| FORD | |
| ’65-’66 Mustang | 57 11/44 |
| ’67-’70 Mustang 8.0 | 59 51/48 |
| ’71-’73 Mustang | 61 11/44 |
What is a strange G body Ford 9 inch rear end?
One such application is the Strange G Body Ford 9 inch rear end that includes mounts, ends, fill, drain, & vent. Strange has increased the strength of the Ford 9 inch in several different ways. The Strange 9 inch housing is a semi-floating, drop-out axle.
What do you think about G-body rearend?
Customer was very pleased with the rearend. Will be ordering from them again. Very friendly and helpful on phone. Everything arrived in tact ready to assemble. I recently purchased a G-Body 9in for my cutlass went with the 35 spline center and axles, disk brakes, back braced with the 1/4 wall tubes.
What size wheels will fit the G-body chassis?
Since our chassis/suspension lowers your vehicle, we do not think 24″ wheels or larger will fit the G-Body chassis without extensive body modification, and/or reduction of turning radius. Which options do I choose? Our 13″ Wilwood kit is great for daily drivers and the occasional autocrosser or road racer.
Is the G-body 9in ready to assemble?
Everything arrived in tact ready to assemble. I recently purchased a G-Body 9in for my cutlass went with the 35 spline center and axles, disk brakes, back braced with the 1/4 wall tubes. Everything lined up perfectly and had no installation issues.