How thick are RockShox Pike stanchions?
Serving as RockShox’s do-everything trail fork, the Pike is available in travel from 120mm to 160mm and sees 35mm stanchions, which add weight but also stiffness.
Does the RockShox Pike have a lockout?
There was also a strong demand from Germany for a Pike fork with a remote lockout. Unfortunately, due to the original Charger damper having a pretty heavy action, fitting a lockout proved problematic, so RockShox redesigned it.
How big are the stanchions on a RockShox Pike?
35mm
Relaunched around a decade ago with a sealed Charger damper, stiff 35mm stanchions and an air-spring tuneable with volume spacers, RockShox’s Pike quickly became the go-to enduro fork.
What pressure should my RockShox be?
RockShox Setup Guide | SRAM. Max pressure should not exceed 163 psi. Rebound suggestions are set from the full clockwise/full slow position. These suggestions are a recommended starting point.
How many bottomless tokens should I use?
Check your fork against the chart below to see if you’re running the correct number of spacers. “For more aggressive riders, I recommend one or two tokens at 160mm”, explains Cancellier. “For each 10mm decrease in travel, I add one token. For example, 150mm would be two or three tokens, 140mm three or four tokens etc.”
What does DebonAir mean in RockShox?
The new DebonAir spring should mean it’s simply a case of inflating to your desired pressure and riding. RockShox also claims riders won’t need to run more air pressure than they normally would to gain support early in the stroke because the newly designed air spring should help the fork ride higher in its travel.
How do you remove the low speed on a RCT3?
RCT3 Low speed RCT3 Compression mode RC Low speed 24 Damper Service RCT3: Use a 2 mm hex wrench to remove the low speed adjuster knob screw. Remove the low speed compression adjuster knob. Use a 6 mm socket wrench to remove the knob retaining nut.
What are the dimensions of the RC RC RCT3?
RC RC RCT3 RCT3 5 6 mm 3.5-4.0 N•m (30-35 in-lb) 6 4 mm 4.0-5.5 N•m (40-50 in-lb) 40 Charger Damper™ Installation
How do you clean the inside of a SRAM RCT3?
Spray isopropyl alcohol on each part and clean with a rag. Apply SRAM® Butter grease to the new seal or o-ring. RCT3: Turn the low speed compression and compression mode knobs counter clockwise until they stop, to the full open positions.
What is the difference between RCT3 RC and RC for compression adjusters?
RCT3:The low speed compression adjuster must be installed properly for the retaining ring to be seated in its grove. RC:The bleed plug must be installed properly for the retaining ring to be seated in its grove. Test the Bleed:Rotate the compression adjuster cam clockwiseuntil it stops. This is the locked position. 8 RCT3 RC 9 10 15 mm