How to reset Buffalo air station?

How to reset Buffalo air station?

With the unit connected to power, hold down the reset button for 3 seconds. This will reset all settings to their defaults.

How do I reset my Buffalo router WZR 600DHP?

To reset the Buffalo WZR-600DHP to its default settings, you have to do the following steps:

1. Put router into operation.
2. For at least 3 seconds, press the Reset button.
3. Device is automatically restarted.
4. Restoration of standard settings is finished.

How do I access my Buffalo router settings?

Buffalo Router Login Open your web browser of choice and type IP address of your Buffalo router in the address bar. You can find the ip address on the back of your router. Now enter the default username and password of your router by accessing the admin panel.

How do I flash the whr-g300n V2?

You can flash the WHR-G300N V2 over the Buffalo web firmware update interface. After which you can then use normal DD-WRT web flashing. See Where do I download firmware for links.

Does Buffalo support the whr-g300n V2 firmware update?

Buffalo, unfortunately, encrypts their firmware, and their routers will accept only encrypted firmware in the web interface. Fortunately, the stunning authors of DD-WRT have created a first time flash file. You can flash the WHR-G300N V2 over the Buffalo web firmware update interface.

How do I reset the wireless main unit to factory settings?

Hold down the Reset button on the bottom for about 3 seconds till the DIAG LED on the front flashes. Release the button when the red DIAG LED on the front flashes. The wireless main unit has been reset.

What is the default Lan IP address of the whr-g300n?

The WHR-G300N has a default LAN IP address of 192.168.11.1* and Subnet Mask of 255.255.255.0. 1. Power down the Cable or DSL modem and the computer which will be used to configure the AirStation router.